Details of the Researcher

PHOTO

Shangping Zhu
Section
Graduate School of Engineering
Job title
Assistant Professor
Degree

  • Doctor of Philosophy in Engineering (Kyushu University)

e-Rad No.
11001868

Research History 2

  • 2023/10 - Present
    Tohoku University

  • 2023/04 - 2023/09
    Kyushu University

Education 2

  • Kyushu University　Interdisciplinary Graduate School of Engineering Sciences

    2021/04 - 2023/03

  • Kyushu Institute of Technology　Graduate School of Life Science and Systems Engineering

    2019/10 - 2021/03

Professional Memberships 1

  • 金属学会

    2020/10 - Present

Research Interests 5

  • 計算科学

  • 組織制御

  • 資源リサイクル

  • イオン電池

  • 電気化学

Research Areas 3

  • Manufacturing technology (mechanical, electrical/electronic, chemical engineering) / Catalytic processes and resource chemistry /

  • Manufacturing technology (mechanical, electrical/electronic, chemical engineering) / Electric/electronic material engineering /

  • Nanotechnology/Materials / Material fabrication and microstructure control /

Papers 7

  1. Pulse regulation enables retained thickening of Mo2C films during molten-carbonate electroreduction Peer-reviewed

    Shangping Zhu, Chongrui Zhuang, Tianqin Liu, Osamu Takeda, Hongmin Zhu

    Materials & Design　116611-116611　2026/07

    Publisher: Elsevier BV

    DOI： 10.1016/j.matdes.2026.116611 　

    ISSN： 0264-1275

  2. Phase‐Field Simulation for the Microstructural Evolution of CuPb 2 F 6 During Defluorination Peer-reviewed

    Shangping Zhu, Hiroshi Akamine, Yusuke Nagahata, Takeshi Tojigamori, Hidenori Miki, Kousuke Noi, Satoshi Iikubo

    physica status solidi (a)　223　(11)　2026/05/31

    Publisher: Wiley

    DOI： 10.1002/pssa.70389 　

    ISSN： 1862-6300

    eISSN： 1862-6319

    More details Close

    The microstructural evolution of CuPb 2 F 6 , a cathode material for fluoride‐ion batteries, during defluorination was investigated using phase‐field simulation coupled with a CALPHAD‐based thermodynamic database. By employing a nonstoichiometric face‐centered‐cubic interstitial solid solution (FCC‐int) description, the simulations capture the nucleation and growth of Cu nanoparticles and reproduce the experimentally observed ∼ 100 nm grain size by tuning the effective nucleation density. A strong correlation among discharge rate, nucleation density, and fluorine diffusion coefficient is revealed, demonstrating that faster discharge rates and higher nucleation densities lead to finer Cu nanoparticles. These trends are consistent with electrochemical measurements conducted at different current densities, indicating that Cu grain size is governed by the concentration gradient within the FCC‐int matrix, which controls nucleation frequency and early‐stage growth. This work elucidates the defluorination mechanism of CuPb 2 F 6 and provides a predictive framework for controlling microstructure evolution, offering design guidelines for next‐generation fluoride‐ion batteries.

  3. Measurement of equilibrium potential of Cl2/Cl− redox couple in molten chloride Peer-reviewed

    Zujian Tang, Qilin Yuan, Shangping Zhu, Osamu Takeda, Hongmin Zhu

    Electrochemistry Communications　107980-107980　2025/06

    Publisher: Elsevier BV

    DOI： 10.1016/j.elecom.2025.107980 　

    ISSN： 1388-2481

  4. Preparation of Uniform Molybdenum Films on Nickel Plate and Nickel Foam Using Electrochemical Deposition in Molten Salt Peer-reviewed

    Chongrui Zhuang, Tianqin Liu, Terigele Terigele, Shangping Zhu, Xin Lu, Osamu Takeda, Hongmin Zhu

    Journal of The Electrochemical Society　172　(5)　052502-052502　2025/05/01

    Publisher: The Electrochemical Society

    DOI： 10.1149/1945-7111/add214 　

    ISSN： 0013-4651

    eISSN： 1945-7111

    More details Close

    Uniform molybdenum (Mo) films were successfully deposited on nickel plates and foam substrates through electrochemical reduction in LiF-KF-KCl-K2MoO4-K2B4O7 melt at 900 °C. For Ni plates, uniform Mo film was achieved via pulse current electrolysis at an average/peak current density of 10/200 mA cm−2, under an electric charge of 72 C cm−2. As the applied charge increased, pulse reverse current electrolysis became essential to maintain the uniformity of the Mo film. For the Ni foam substrate, a series of comparisons of electrolysis parameters revealed that the use of pulse reverse electrolysis and an increase in the ratio of anodic dissolution in the electrolysis design help to increase the uniformity of the Mo film. This process required a careful balance of anodic dissolution in each cycle, ensuring even deposition under conditions of high electric charge density.

  5. Microstructure control and its observation of rapid solidification Cu–La alloy for the development of fluoride-ion batteries Peer-reviewed

    S. Zhu, H. Akamine, Y. Nagahata, T. Tojigamori, H. Miki, Y. Zhang, T. Tokunaga, S. Iikubo

    Journal of Alloys and Compounds　930　167447-167447　2023/01

    Publisher: Elsevier BV

    DOI： 10.1016/j.jallcom.2022.167447 　

    ISSN： 0925-8388

  6. Bimetallic Sulfide SnS2/FeS2 Nanosheets as High-Performance Anode Materials for Sodium-Ion Batteries Peer-reviewed

    Yun Chen, Hongbin Liu, Xiaolin Guo, Shangping Zhu, Yue Zhao, Satoshi Iikubo, Tingli Ma

    ACS Applied Materials & Interfaces　13　(33)　39248-39256　2021/08/11

    Publisher: American Chemical Society (ACS)

    DOI： 10.1021/acsami.1c08801 　

    ISSN： 1944-8244

    eISSN： 1944-8252

  7. Potential-pH Diagram during Acid Leaching Process of Waste Phosphor,废旧荧光粉中稀土元素浸出的电位-pH图

    Liao, C., Zhong, L., Zeng, Y., Zhu, S., Li, Z.

    Xiyou Jinshu Chinese Journal of Rare Metals　43　(2)　2019

    DOI： 10.13373/j.cnki.cjrm.XY18010033 　

    ISSN： 0258-7076

Show all ︎Show first 5

Misc. 3

  1. Thermodynamic properties of Cu-Pb-F ternary system for the development of fluoride-ion batteries Peer-reviewed

    ZHU Shangping, HARADA Hideyuki, KAWANO Shoya, YAMAMOTO Kumiko, MIKI Hidenori, TOJIGAMORI Takeshi, NOI Kousuke, IIKUBO Satoshi, IIKUBO Satoshi

    九州大学大学院総合理工学報告(Web)　44　(2)　2023

    ISSN： 1346-7883

  2. Reaction mechanism of CuS positive electrode for all-solid-state fluoride ion batteries

    野井浩祐, 藤波想, 仲谷友孝, 松海壯一郎, ZHU Shangping, 飯久保智, 中西康次, 山中俊朗, 下田景士, 佐藤和之, 三木秀教, 安部武志

    電池討論会講演要旨集(CD-ROM)　64th　2023

  3. Preparation and evaluation of Cu-S positive electrodes for all-solid-state fluoride ion batteries

    野井浩祐, 三木秀教, 仲谷友孝, 藤波想, 中西康次, ZHU Shangping, 藤原慎太郎, 飯久保智, 安部武志

    電池討論会講演要旨集(CD-ROM)　62nd　2021

Presentations 1

  1. 融MgCl2-NaCl-KCl中での電析アルミニウムの析出形態

    朱 尚萍, 山内 結理, 竹田 修, 朱 鴻民

    日本金属学会2025年秋季（第177回）講演大会　2025/09/19

Teaching Experience 3

  1. 材料科学総合学実験　東北大学 工学部 材料科学総合学科

  2. 数学物理学演習II　東北大学 工学部 材料科学総合学科

  3. 創造工学研修　東北大学 工学部